This device will test seal integrity on parts during assembly. Operation is simple, assemblers hold the part to test onto the nozzle and activate a momentary switch to draw a vacuum. Then watch the gauge to see any leakage.
This is the left half of a custom drying rack. The right half is a mirror image of this and the two halves are held together with dowel rods. It provides a convenient way to keeps parts separate while drying.
Ever wanted to modify existing equipment? This is an extension table we made for supporting parts longer than the original press would accommodate. It screws onto the existing frame and extends the register edge for long parts.
Customers often use proprietary processes which we can’t explain in any detail here. This block is an example showing individual well pockets for keeping samples separated for testing. The pockets taper deeper on one end.
This little device puts a scribed line on a clear plastic tip (like a calibration line). The part is inserted vertically, then rotated by hand while the clamped wheel cuts a line at a set depth. These parts snap on to a small flash light and provide visual feedback on depth of insertion. We went with a scribed line because printed lines wear off too easily when cleaning between uses.
Hearing aids need to be tested or calibrated precisely on a sound proof enclosure. This customer’s setup requires that the hearing aid being tested be presented at a precise elevation and distance from the sound source. This fixture does just that.
Stands for glue syringes can just be purchased from stock, but sometimes having something custom is a better answer. We made these inexpensive stands in 1/4 ABS. The customer uses a variety of adhesives dispensed from syringes that also vary in size. This custom stand keeps mess-free and ready for use.